Here is the latest downloaded from the netgear site: First, Set Up the WG602v4 1. ©2007 by NETGEAR, Inc.

hitting the reset pin for a second or so usually doesn't wipe out the NVRAM, you usually have to hold it, and i recommend anywhere from 30-90 seconds. Actually, I was just rereading the instructions yet again and I realized the Step 1 Heading: " options.

see rouer reset on my sig below.

However, I want to change the security settings and I cannot access the configuration page. The service includes support for the following:Protect and support your recent NETGEAR purchase. First, I misspoke.

Was this article helpful? Hi, I have a WG602v4. Please help

If this PC is already part of your network, record its TCP/IP configuration settings.

CONNECT THE WIRELESS ACCESS POINT TO YOUR COMPUTER AND MODEM a. Unpack the box and verify the contents.

Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.

READ the Peacock Thread first. Auch Unterstützung und erhalten Sie das Handbuch per E-Mail.

Configure the PC with a static IP address of 192.168.0.210 and 255.255.255.0 …

Re: WG602v4 - Can't access configuration page Initial Preparation Before Use Read This First. to verify wireless network connectivity.

Hi, I'm going to pile on this thread because I have the SAME TOPIC problem and figure might as well NOT add yet another thread about setting up the WG602v4.

WG602v4 to establish a wireless connection to the WG602v4.

Prepare a PC with an Ethernet adapter. Have you tried holding the reset pin for 30-60 secs?

any step by step tutorials? Geben Sie bitte Ihre Email-Adresse ein.NETGEAR 54 Mbps Wireless Access Point WG602v4 Reference Ma

Please refer to the online Reference Manual for instructions on advanced configuration. Manual is on the Resource CD.

Just tried it on a Ubuntu Linux box and while it did not access the 602, the browser got "stuck" and did not get to the point where it gives up and says cannot open page. I guess I could try it again.

This explains how to do wireless repeating with NETGEAR access points. Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.

(amber for a 10 Mbps connection and green for a 100 Mbps connection).

I get to step 2a and it says enter 192.168.0.227 and i do but nothing happens!

Wenn Sie eine Meldung übermitteln, überprüfen wir Ihre Informationen und ergreifen entsprechende Maßnahmen.

The ... "I understand that you are getting the Region as USA on the configuration page of WG602v4."

NETGEAR Support. Page 2: Technical Support WEEE Directive. If this PC is already part of your network, record its TCP/IP configuration settings.

Re: WG602v4 - Can't access configuration page

NETGEAR ProSupport for Business.

Wir setzen uns dafür ein, derartige Missbrauchsfälle gemäß den Gesetzen Ihres Heimatlandes zu behandeln.

Yes, I did the reset pin.

If options. GearHead Technical Support makes it easy to fix issues on not just your NETGEAR purchase but for your entire home network.

WG602v4 - Can't access configuration page

A link to the NETGEAR WG602v4 54 Mbps Wireless Access Point Reference not, make sure the Ethernet cable is securely attached at both ends. If your network is 192.168.0.x then you should able to reach it

Maybe something has buggered his config settings, which is why I am recommending a reset now before sending the device back.

Here is the latest downloaded from the netgear site: First, Set Up the WG602v4 1.